Ignition switch wiring sequence?

Hi Folks,
I am looking for some help with the correct wiring for the ignition switch/lock on my 1995 110.

At present it has a non standard ignition switch fitted, this was on the vehicle when i bought it, I have finally got round to changing it for an original part, however when i stripped it down it became aparent that the terminals on this switch are not the same as the new landrover switch. I think the switch that is currently fitted is from a tractor or similar ignition setup, there is no steering lock as such just the switch and key setup.

At this stage i decided to rebuild and seek advise regarding the correct wiring sequence.

If someone could tell me which colour wire goes to which terminal (1,2,3,4 ect) that would be great.

regards

Ermm ,well. I've recently become an expert on this very subject.

Be so good as to post what wire colours you have, and a picture of the back end of your switch, and I will try to help you out.

Make sure you have some fuel in your tank first though...

Thanks for the quick response, I have rebuilt the dash so will strip down sunday and take note of the wire colors, how do I go about posting picture though, could you give me an email address?
cheers
james

I'll send you a pm.