Any advice for removing the two security pins which hold the ignition lock assembly in place on a Puma Defender 90 (2015) please? I’ve sourced a replacement including new security pins and want to try the repair myself. Am thinking of using a pin punch to loosen the existing pins? Thanks for any advice.
Ignition Lock Removal
- Thread starter NickBa
- Start date
This site contains affiliate links for which LandyZone may be compensated if you make a purchase.
tottot
Well-Known Member
- Posts
- 7,459
- Location
- west wales coast
Humm,
Anaconda
Well-Known Member
- Posts
- 1,983
- Location
- Thames Valley
What's wrong with the current one?
Everyone has to have a first post I guess? I’m new to Land Rover Ownership and this is my first fault which I wanted to do myself. The ignition switch wouldn’t turn at all. After a few hours of gentle WD40 assisted persuasion and an RAC recovery to home, the key now works again but it’s not a smooth operation. Replacing the switch assembly seems a sensible move so I asked for advice on the forum. Didn’t expect an outright rebuff.
Anaconda
Well-Known Member
- Posts
- 1,983
- Location
- Thames Valley
I am sure you must know that Defenders get stolen all the time, that is why any security questions as a first post will be looked at with suspicion.
Saying that you would be a pretty poor thief if you can't break an ignition barrel!
Try your punch, it might work, otherwise drill the bolts out.
Or you could try WD40 dry PTFE spray first.
- Posts
- 3,891
They do, typically this is an introduction.
//
Hi, my names (insert) and i'm near (town).
I have a (make model year) landrover and recently had to get recovered by the RAC because (A B C).
Heres a picture <insert>
Here's my problem, what do you guys suggest ?
\\
Not - "How do I remove these security bolts on the ignition."
Last edited:
RustyDefender
Well-Known Member
- Posts
- 463
- Location
- Lake District
beat me to it
