yellowmitch
New Member
- Posts
- 19
Hi there. I want to remove the rear D pillar trims on my 1989 classic to do some welding and also remove the rear wings for inspection and a repaint.
How?
How?
how to remove parts of a 1989 classic?
- Thread starter yellowmitch
- Start date
This site contains affiliate links for which LandyZone may be compensated if you make a purchase.
Sirus
Your all Banned except me
- Posts
- 22,196
- Location
- The Country of Black
has you got a lisp?
yellowmitch
New Member
- Posts
- 19
An answer of actually how to do the job properly would be handy 
ironhorse
Active Member
- Posts
- 280
- Location
- West Sussex
The rear corner section has two self tapping screws and pop rivets holding it in place, the rear wing is the same set up, just drill the heads off the rivets
yellowmitch
New Member
- Posts
- 19
Unfortunately, I don't see the rivets. I am talking about the outer - vinyl covered - "D" post trims. I see where they are screwed on in the boot void but cannot see where the outer bits are screwed or riveted on. It looks like they are bolted and the back window has to come out to let u work in there
supapete
Active Member
- Posts
- 505
- Location
- West wing I think
I did that many body repairs to my classic I've honestly forgotten some of the tricks. I can't remember this as being more impossible than anything else. Have you looked here? http://www.landrover.ee/est/files/manuals/cars/rrc/rrm_chassis_body.pdf
ironhorse
Active Member
- Posts
- 280
- Location
- West Sussex
There are two screws on the rear most edge, and 3 screws on the forward edge. The forward screws are screwed through a plate about an inch wide running vertical up the panel inside the vehicle. I can’t be sure if you have to remove the window, maybe a land rover supplier could verify
