I have a 1996 Discovery 300TDi. I'm replacing the rear floor panel. While doing so, I took a look at the rear wheel arches (the things that protrude into the rear of the vehicle, not the little bit that runs along the door edge). The offside one looks as though it's shortly going to resemble a swiss cheese, it's bubbling that much rust. How easy are these panels to take out and replace, and where can one get instructions on how to do it?
Hi, New Member, needing advice.
- Thread starter Kiwi Jim
- Start date
This site contains affiliate links for which LandyZone may be compensated if you make a purchase.
Shimsteriom
Master Procrastinator
- Posts
- 41,906
- Location
- Over Here
Welcome to the forum 
Best ask technical questions in the relevant section as it'll get more views. This section is for peeps to say Hi, and post piccies of their car.
https://www.landyzone.co.uk/forum/land-rover-discovery.8/
Best ask technical questions in the relevant section as it'll get more views. This section is for peeps to say Hi, and post piccies of their car.
https://www.landyzone.co.uk/forum/land-rover-discovery.8/
