- Posts
- 2,427
- Location
- Isle Sheppy
How can I test the wiring that goes to to the rear height sensors as one isn’t working properly and it’s new any tips greatly appreciated either with a nanocom or multimeter
P38A Height sensor wiring
- Thread starter pete12345
- Start date
This site contains affiliate links for which LandyZone may be compensated if you make a purchase.
- Posts
- 33,940
- Location
- North Shropshire
Can you measure the resistance of the height sensor? It could be duff?
- Posts
- 2,101
- Location
- Mull of Kintyre
Unplug it and spray contct cleaner on plug and socket a few times
- Posts
- 12,660
- Location
- Sud ouest France !
Swap em over Pete!
RangeRoller dt
Well-Sprung Member
- Posts
- 14,413
- Location
- Trapped inside my head @ LZ asylum
Use fly leads that reach to the ends of where you want to test for continuity.
Whole length of the vehicle if you need, follow the loom
Whole length of the vehicle if you need, follow the loom
- Posts
- 2,427
- Location
- Isle Sheppy
Thanks for suggestions the swapping over bit shouldn’t come into it because there both new and that left side was throwing a fault before I replaced them so will check the wire and clean up
RangeRoller dt
Well-Sprung Member
- Posts
- 14,413
- Location
- Trapped inside my head @ LZ asylum
Oh sorry , I meant the wiring running to the sensor along the chassis.
- Posts
- 2,427
- Location
- Isle Sheppy
All suggestions appreciated found the problem on rear left sensor plug round wrong way just going to adjust the heights today but all working well now going up/down and in an out thank Christ onwards and upwards next job
- Posts
- 2,101
- Location
- Mull of Kintyre
I like the easy ones well done
