Eavning all, I'm fitting a safri copy snorkel on my 2.5 n/a on the right hand side wing. Where the snorkel goes through the wing the heater matrix unit is there. As mine is broken anyway I'm going to remove it and plumb the.snorkel in. I'm asking how hard is it and how to remove the heater matrix off the bulkhead. the pipes are already disconnected all i need to do is remove it and I'm not sure how as I can't get a good look and see where its attached. Thanks for the help.
Heater matrix removal for snorkel.
- Thread starter MaxyMan
- Start date
This site contains affiliate links for which LandyZone may be compensated if you make a purchase.
big si
Well-Known Member
- Posts
- 4,651
- Location
- black country
4 m6 bolts on inside of bulkhead passenger side, you shouldn't have to remove it though.
big si
Well-Known Member
- Posts
- 4,651
- Location
- black country
fitted a copy to my 90 but mine has the intake on the side of wing to fit to but it definitely fits under the plastic intake from the wing top ,it is easier to fit with the plastic intake removed but still awkward to do up the nuts anyway. give it a go mate.
big si
Well-Known Member
- Posts
- 4,651
- Location
- black country
i didn't ,they are just on the bit that slopes down from the knee panel/junk tray
