dashwoodlandy
Member
- Posts
- 62
- Location
- Kenilworth, Warwickshire.
Just kidding about a group meeting, not sure Ian's bees would like a load of RR buzzing around their field, let alone the land owner.
Got stuck again !!!!!!!
- Thread starter Ianwallace
- Start date
This site contains affiliate links for which LandyZone may be compensated if you make a purchase.
Just kidding about a group meeting, not sure Ian's bees would like a load of RR buzzing around their field, let alone the land owner.
- Posts
- 18,969
- Location
- Buckinghamshire, UK. ('95 DT)
Maybe he owns the field?
Don't think the bees mind as long as we stay away from their heather. Do they get heather in Wiltshire? Probably clover flowers on reflection.
Don't think the bees mind as long as we stay away from their heather. Do they get heather in Wiltshire? Probably clover flowers on reflection.
Ianwallace
Active Member
- Posts
- 288
- Location
- Calne Wiltshire
Thank you for the info guys. I would love to meet up. The field is a private field as owned my a farmer and don't want to upset him. So only could take one car. But would love to meet up. Even for you guys to pick any faults my car has?
I have seen this happen a lot with the RR (p38) I have a DSE with no TC and whilst it will do all sort off road with no problems I had to pull it out of a slightly slippy wet field with my freelander on the last trip. It's just that they are heavy and early loose traction to spin the wheels. I bet that it happens not at all or a lot less with 4 wheel TC
Ianwallace
Active Member
- Posts
- 288
- Location
- Calne Wiltshire
- Posts
- 18,969
- Location
- Buckinghamshire, UK. ('95 DT)
I've got the rear wheel TC in mine. Not a lot of difference although seems to help on snow. Would love to have a go with 4W TC and compare!
dashwoodlandy
Member
- Posts
- 62
- Location
- Kenilworth, Warwickshire.
I had 4 wheel traction control on my 05 defender, the problem I always found was that in order to get it operating you needed the wheels to spin, which on really wet mud was easy, but because it was so easy if the wheels spun too much the TC would overheat and turn itself off without the driver knowing. My mates Disco 3 was completely different, very capable even on road tyres on the same terrain, you could see the wheels spin then stop, it almost looked like it was clawing itself out of the mud, shame everything else on it was so unreliable.
I prefer good old fashioned driver ability (or lack of it when I get stuck).
I prefer good old fashioned driver ability (or lack of it when I get stuck).
- Posts
- 18,969
- Location
- Buckinghamshire, UK. ('95 DT)
Traction control on a Defender?! Sacrilege. Tell me it still had diff-locks?
Guess that it depends on the TC system, but without lockable diffs i honestly don't think you can sniff at TC.
I'm sure I read something that you can upgrade to 4 wheel TC if you have rear wheel? Well maybe or maybe not.
Or get a freelander as a recovery vehicle
- Posts
- 18,969
- Location
- Buckinghamshire, UK. ('95 DT)
If you have no TC then you can upgrade the brake modulator and the ABS computer and get rear TC.
The modulator and the ABS computer pins are different for the 4W TC. I saw a thread on another site saying the guy had worked it out (he thought) but his car was wrecked shortly afterwards and you've got to wonder if he got it right!
Or get a freelander as a recovery vehicle
StuckAgainSteve
Well-Known Member
- Posts
- 2,276
- Location
- London
RE the posts about the VCU - IMHO a seized VCU will give you more traction on very slippy surfaces in a straight line - so even if it is seized - it's not the cause of your problem.
Datatek
Well-Known Member
- Posts
- 43,990
- Location
- Near Poitiers SW France
Mine has 4 wheel TC, it really struggles on a wet grassy slope that my Pajero with a centre diff lock and rear LSD went up with no problem.
- Posts
- 18,969
- Location
- Buckinghamshire, UK. ('95 DT)
That doesn't surprise me. My old H plate Defender went through just about anything with diff lock on. LSD would help too.
No doubt that wet, muddy fields are worse than snow!
Doesn't help Ian, mind. Well, it does, Kamlockers next! Pity about locking that VCU.
Ianwallace
Active Member
- Posts
- 288
- Location
- Calne Wiltshire
Ok guys firstly on the low range what gear should I have used?
There is a picture of a truck going up and down.
Also how do I know if my truck has front or read TC
I really don't know anything about driving off road on this thing
So any advice is very much appreciated
On my trooper it was manual and I only used hi range and I could drive it anywhere never got stuck
I don't want to start upgrading things on this truck. Costing me a fortune as it is
There is a picture of a truck going up and down.
Also how do I know if my truck has front or read TC
I really don't know anything about driving off road on this thing
So any advice is very much appreciated
On my trooper it was manual and I only used hi range and I could drive it anywhere never got stuck
I don't want to start upgrading things on this truck. Costing me a fortune as it is
- Posts
- 18,969
- Location
- Buckinghamshire, UK. ('95 DT)
I'd use low 3 but not with the manual button pressed.
4W TC control came as standard in about 1999, I think. Before that was rear or none.
Ianwallace
Active Member
- Posts
- 288
- Location
- Calne Wiltshire
Morning guys
I've jacked up my car today to test the wheel thing
Do I need a big bar thing to turn the wheel
I've tried to turn the wheel by hand and it's not turning
But regarding the other comment about going round corners and feeling it bind or something I've been round many tight corners and it feels very smooth
I've jacked up my car today to test the wheel thing
Do I need a big bar thing to turn the wheel
I've tried to turn the wheel by hand and it's not turning
But regarding the other comment about going round corners and feeling it bind or something I've been round many tight corners and it feels very smooth
- Posts
- 58,170
- Location
- Preston Lancs.
You should be able to turn the wheel by hand. It should move slowly with steady pressure applied, will be difficult to move but never the less should move.
dashwoodlandy
Member
- Posts
- 62
- Location
- Kenilworth, Warwickshire.
Datatek
Well-Known Member
- Posts
- 43,990
- Location
- Near Poitiers SW France
You need the gear lever in neutral. Needs a lot of effort.
StuckAgainSteve
Well-Known Member
- Posts
- 2,276
- Location
- London
As I said before a sized VCU would effectively be a centre diff lock - it is not your problem.
