gearbox-swapping

RR gearbox into a disco...

how many differences, how many potential problems?


They're both LT77s AFAIK (not actually seen the replacement one yet) and I
don't know but I assume the RR one is from a V8. My disco is a V8, of
course.

--
Austin Shackles. www.ddol-las.fsnet.co.uk my opinions are just that
Satisfying: Satisfy your inner child by eating ten tubes of Smarties
from the Little Book of Complete B***ocks by Alistair Beaton.

> RR gearbox into a disco...
>
> how many differences, how many potential problems?
>
>
> They're both LT77s AFAIK (not actually seen the replacement one yet) and I
> don't know but I assume the RR one is from a V8. My disco is a V8, of
> course.

I sure they will both have the same length bellhousing and shaft, just as
long as there are no difrences between the gear leaver positions I can't see
any probs that I know of...
Toby

"TVS" <[email protected]> wrote in message
news:[email protected]...

> I sure they will both have the same length bellhousing and shaft, just as
> long as there are no difrences between the gear leaver positions I can't
> see
> any probs that I know of...
> Toby

Pay attention to the handbrake mode of operation and the way the cable is
secured in the bottom of the centre glovebox wotsit. I think there was a
change on the Rangie around 1989/90.

Lee D