gearbox oil

sparkysbandit · Jan 22, 2013

what would you guys recommend as a decent oil

also, is it an easy DIY job to change

iv got a 1.8i 2002 model

Freelaner · Jan 22, 2013

mtf 94

http://forums.mg-rover.org/showthread.php?t=148788

sparkysbandit · Jan 23, 2013

cheers bud, looks like a good idea.

whats the access to the filler/drain plug lke?

Freelaner · Jan 23, 2013

it would be a lot easier if you take the airbox off.

simple to do just unbolt the two 8mm bolts on the inside of the battery tray then pull off the hose to the throttle body and then the one at the front behind the headlamp.

sparkysbandit · Jan 23, 2013

cheers,

a nice little job for my son

Singvogel · Jan 23, 2013

2 litres of MTF94 -available at Halfrauds, Eurocarparts etc.

It is not so easy to refill the box.

I would suggest:

4 bricks - one under each wheel. You don't need ramps - but if you have them you need 4 so car is level. This makes getting the undertray off easy.

A sryinge to refill it with.

Take out the filler plug first - it has been known that folks drain out the old oil only to find they can't refill.

Same applies to the IRD - which is easy to do at the same time.
It takes 1.1 litres of 75W-90 Gear Oil.

Edit: just checked that MG link - I think using a syringe is easier than a funnel.

sparkysbandit · Jan 23, 2013

Singvogel said:
2 litres of MTF94 -available at Halfrauds, Eurocarparts etc.

It is not so easy to refill the box.

I would suggest:

4 bricks - one under each wheel. You don't need ramps - but if you have them you need 4 so car is level. This makes getting the undertray off easy.

A sryinge to refill it with.

Take out the filler plug first - it has been known that folks drain out the old oil only to find they can't refill.

Same applies to the IRD - which is easy to do at the same time.
It takes 1.1 litres of 75W-90 Gear Oil.

some good suggestions there dude, cheers.

now here's the idiot question

what's the IRD and where is it?

Nodge68 · Jan 23, 2013

sparkysbandit said:
some good suggestions there dude, cheers.

now here's the idiot question what's the IRD and where is it?

The IRD is the Freelander's equivalent to a transfer box. It's bolted to the engine side of the gearbox. The drivers side drive shaft comes out of it!!

sparkysbandit · Jan 23, 2013

Nodge68 said:
The IRD is the Freelander's equivalent to a transfer box. It's bolted to the engine side of the gearbox. The drivers side drive shaft comes out of it!!

ah right i see...

iv never had a land rover or any4x4, im used to simple things like "vectra's and motor bikes" etc
but im sure with good advice off you guys i'll get to grips with it...oh and my haynes manual iv just ordered

gearbox oil

sparkysbandit

Active Member

Freelaner

Landy Driver

sparkysbandit

Active Member

Freelaner

Landy Driver

sparkysbandit

Active Member

Singvogel

Well-Known Member

sparkysbandit

Active Member

Nodge68

Well-Known Member

sparkysbandit

Active Member

Similar threads