James , thought id start a new thread , thought you might read this as I hijacked another thread with my questions..
Quote:
Originally Posted by jamesmartin
is reverse lever set on shaft properly allowing full selection ,is it a new reverse ,originally reverse idler needle bearing had a slight twist this helped hold into gear new ones are often straight
its an old reverse gear. Ive built a few series gearboxes and have been lucky with reverse as I never changed them out. but I did fit a new needle roller bearing on this one. I thought the fork setup was correct but not sure. i havent pulled the top off again. the strange thing is it didn't do that before.
It feels like its getting full selection but it sometimes dosent. Sometimes i select the gear and when i pull the clutch up slowly its not meshing properly and gives that token grinding noise. do you think its prob the fork setup?
Quote:
Originally Posted by jamesmartin
is reverse lever set on shaft properly allowing full selection ,is it a new reverse ,originally reverse idler needle bearing had a slight twist this helped hold into gear new ones are often straight
its an old reverse gear. Ive built a few series gearboxes and have been lucky with reverse as I never changed them out. but I did fit a new needle roller bearing on this one. I thought the fork setup was correct but not sure. i havent pulled the top off again. the strange thing is it didn't do that before.
It feels like its getting full selection but it sometimes dosent. Sometimes i select the gear and when i pull the clutch up slowly its not meshing properly and gives that token grinding noise. do you think its prob the fork setup?
Last edited:
