martyn gadgetman002
New Member
- Posts
- 23
on my p38 the message: gearbox fault flashed up today anyone got any ideas !!!
gearbox fault message
- Thread starter martyn gadgetman002
- Start date
This site contains affiliate links for which LandyZone may be compensated if you make a purchase.
Cut-n-Paste from rangerovers.net
One interesting incident I experienced was the appearance of the "gearbox fault" message every time I went round a sharp right hand curve. The problem eventually proved to be a loose connector in a part of the harness that connects to the electronically controlled transmission. I have since heard from several other owners with the "Gearbox Fault" message. It apparently indicates that voltage to the transmission selector mechanism is insufficient. Another cause is failure of the transfer box ECU to communicate with the BeCM due to a bad connection or connector.
One interesting incident I experienced was the appearance of the "gearbox fault" message every time I went round a sharp right hand curve. The problem eventually proved to be a loose connector in a part of the harness that connects to the electronically controlled transmission. I have since heard from several other owners with the "Gearbox Fault" message. It apparently indicates that voltage to the transmission selector mechanism is insufficient. Another cause is failure of the transfer box ECU to communicate with the BeCM due to a bad connection or connector.
martyn gadgetman002
New Member
- Posts
- 23
it only started after i tryed to jump start my other range rover classic
