retneprac
Well-Known Member
- Posts
- 2,035
- Location
- Bedfordshire
Anyone know the correct size bits to in-do the above filler points?
Cheers.
Cheers.
Gear and transfer box fluid filler.
- Thread starter retneprac
- Start date
This site contains affiliate links for which LandyZone may be compensated if you make a purchase.
neilly
Well-Known Member
- Posts
- 20,000
- Location
- Oxfordshireness
You mean the torx and square drive sizes?
Or the kit to make the work easier?
Cheers
Or the kit to make the work easier?
Cheers
Turboman
Mab An Gov
- Posts
- 60,151
- Location
- Lathrowda, Kernow
I think you can use the drive square of a half inch ratchet. But I use a half inch drain plug key, they are cheap. A tap with a hammer can assist if the plugs are tight.
retneprac
Well-Known Member
- Posts
- 2,035
- Location
- Bedfordshire
Der, its a TD5, its a torx bit.
Just checking levels really.
Short story, new clutch, mass fly, everything.
Now get bad vibes when in gear going up the revs, its back in garage next week for a check but thought it prudent to check as much as poss before, fluid levels, props, mounts, etc.
Just checking levels really.
Short story, new clutch, mass fly, everything.
Now get bad vibes when in gear going up the revs, its back in garage next week for a check but thought it prudent to check as much as poss before, fluid levels, props, mounts, etc.
neilly
Well-Known Member
- Posts
- 20,000
- Location
- Oxfordshireness
iirc , the G box is T50 or T55, but I would recommend checking.
My Tbox last time I did it ( D2 TD5 ) was either 1/2 or 3/8 ( leaning towards 1/2 ) square drive.
Cheers
My Tbox last time I did it ( D2 TD5 ) was either 1/2 or 3/8 ( leaning towards 1/2 ) square drive.
Cheers
bankz5152
Well-Known Member
- Posts
- 9,391
- Location
- South London/North Kent
1/2" did mine recently
neilly
Well-Known Member
- Posts
- 20,000
- Location
- Oxfordshireness
bankz5152
Well-Known Member
- Posts
- 9,391
- Location
- South London/North Kent
Nah GB is torx for the fill and 22mm (i think) spanner for the drain + crush washer
mojo247
Active Member
- Posts
- 628
- Location
- Ciderland!
torx55?
