Frosted
Active Member
- Posts
- 156
- Location
- North of london
Have no bulkhead,doors wings etc fitted and had to replace a outrigger.
I did take a load of measurements but replacement part was not lining up.
Had a look at the manual and measurement 7 looked like the bolt just forward of the outrigger.
But the measurement to the datum is completely out. Anyone know what that is then?
Only way I had was to match the other side height. So I used a spirit level on the bolt over to the chassis rail and measured the vertical distance from the rail which would make the spirit - level.
Then I think/hope I can use this same delta and the spirit level on the new side to get it at right/same level?
Bit late now as its welded on anyway but any other suggestions?
I guess I have to wait to I put it back together find out if it worked!
I did take a load of measurements but replacement part was not lining up.
Had a look at the manual and measurement 7 looked like the bolt just forward of the outrigger.
But the measurement to the datum is completely out. Anyone know what that is then?
Only way I had was to match the other side height. So I used a spirit level on the bolt over to the chassis rail and measured the vertical distance from the rail which would make the spirit - level.
Then I think/hope I can use this same delta and the spirit level on the new side to get it at right/same level?
Bit late now as its welded on anyway but any other suggestions?
I guess I have to wait to I put it back together find out if it worked!
