front disks replacement

iwallace · Sep 1, 2012

hi ppl.
went to change my disks and pads today on my defnder 110,
it was a little more involved then i thought.
stripped it all down to expose the washer on the bearing, but i could not slide the disk off the shaft, pulled the washer and outer bearing out, flopped around but would not slide off.....
is there something i should of undone or should i of been a little more aggressive..
i feel quite gutted.............done 1000s of disks and brakes b4,
just not on a landy.
done searches but i couldnt find anything on the defender.
cheers for your help
ian

craigyb · Sep 1, 2012

You need to undo swivel pins. Top n bottom and ring of bolts at back holding the seal in

Pikey · Sep 1, 2012

craigyb said:
You need to undo swivel pins. Top n bottom and ring of bolts at back holding the seal in

Why??? all he wants to do is change front discs?? It should pull straight off the shaft.

If it doesn't it's probably the inner race on the wheel baering seized to the shaft.

craigyb · Sep 1, 2012

redhand said:
Why??? all he wants to do is change front discs?? It should pull straight off the shaft.

If it doesn't it's probably the inner race on the wheel baering seized to the shaft.

Which is why I said what I said

iwallace · Sep 1, 2012

i undone the 2 bolt at the top, that hold the brake line in place, is there 2 underneath that have to be taken off??
and do you mean the ring of bolts inside the disk hub, which i can only get at when the disk is of.
thanks again

Pikey · Sep 1, 2012

craigyb said:
Which is why I said what I said

Big bar or an hammer on the back of the disc will knock it off the inner race then just needs to crack the seized race with a cold chisel

No need to take hub off at all.

3.5 efi · Sep 1, 2012

iwallace said:
hi ppl.
went to change my disks and pads today on my defnder 110,
it was a little more involved then i thought.
stripped it all down to expose the washer on the bearing, but i could not slide the disk off the shaft, pulled the washer and outer bearing out, flopped around but would not slide off.....
is there something i should of undone or should i of been a little more aggressive..

shoulda smacked fook out of it with a big hammer!

iwallace · Sep 1, 2012

i had my hammer ready , just wasnt sure if there was anything else to undo.....

Pikey · Sep 1, 2012

iwallace said:
i had my hammer ready , just wasnt sure if there was anything else to undo.....

Assuming ya removed the Calliper??? then no just the Hub nuts,

Let us know how ya get on..

iwallace · Sep 1, 2012

calliper was off....
round 2 tomorrow

iwallace · Sep 2, 2012

typical.................a simple tap with the hammer. it slid off

cheers for help.
ian

iwallace · Sep 4, 2012

both disks and pads done, front bearings replaced, drained one side of the swivel bearing and replaced with new oneshot grease...
but the drivers side has no drain nipple,
is there and easy way to drain the old out,,
im still learning on this beast
thanks ian

front disks replacement

iwallace

Active Member

craigyb

New Member

Pikey

Dummy Ejection Facilitator..

craigyb

New Member

iwallace

Active Member

Pikey

Dummy Ejection Facilitator..

3.5 efi

Well-Known Member

iwallace

Active Member

Pikey

Dummy Ejection Facilitator..

iwallace

Active Member

iwallace

Active Member

iwallace

Active Member

Similar threads