front bumper
- Thread starter poppysdad
- Start date
This site contains affiliate links for which LandyZone may be compensated if you make a purchase.
brianp38dse
Well-Known Member
- Posts
- 19,593
- Location
- heathrow
Not a hard job as long as the fixings come undone, have you downloaded the LR workshop manual Rave its all in there if you haven't it can be found in the Techarchive top left of the range rover section Wazzarjnr put up a load of links
Rave is like a Haynes but on steroids .
here`s the page https://www.landyzone.co.uk/land-ro...lus-other-useful-info-on-range-rovers.322195/
Rave is like a Haynes but on steroids .
here`s the page https://www.landyzone.co.uk/land-ro...lus-other-useful-info-on-range-rovers.322195/
Last edited:
Thanks I will take a look
- Posts
- 18,969
- Location
- Buckinghamshire, UK. ('95 DT)
Dead easy. Fold down clip at each side, two torx bolts underneath where the chassis legs stick through. Push down in the middle till it clunks then wriggle it forward. If you have fogs then have a couple of recycling baskets or similar to catch it otherwise the full weight will yank the cables. Unplug the fogs and you're done. I've made paracord leashes to catch it before it starts pulling on the fog light cables.
That's easy for you to say ha ha. will this all become clear when I look at it ? are there any pics on this site to follow ? Thank you
- Posts
- 18,969
- Location
- Buckinghamshire, UK. ('95 DT)
Don't know about pics. Saint might have posted some. As soon as you get you head under there it'll be blinding obvious apart from the push down part. That'll be obvious once it is off!
Thank you as soon as it warms up I will have a look .
