freelander 2

Hi all my name is Glenn I'm new to landyzone and forums in general. I have a freelander 2 which is being a pain in the but, its been to 2 garages and had injectors as it blew the ends of the last ones, then 2 days after getting back the turbo went which I changed myself and broke down on my way home AA recovered it to another garage who told me the engine had blown. I have some mechanical knowledge and they where full of it but it was a high mileage engine 280k so I've replaced the engine myself but the reason it broke down must still there because it wont start. its get fuel up to the injectors after a lot of priming but I have plugged a noid into injector harness and there is nothing on cranking also checked with amp meter. there are 3 fault codes that wont clear down.
P2564 - PENDING
P0131 - O2 sensor heater sensor circuit low voltage(bank 1, sensor 1)
P0642 - unknown
and 1 that comes back after cranking -
P0340 - camshaft position sensor A circuit (bank 1 or single sensor)
I have changed the cam and crank sensors.
any advice/suggestions would be great.
many thanks

Welcome

I have no knowledge of the FL so can’t help.
All I could say is, immobiliser? Crank but no fire maybe.
Or back to your crank an cam sensors and check.

Anyway the gurus hang out here

https://www.landyzone.co.uk/forum/land-rover-freelander.9/

So it’s a better place to ask for tech questions.

Good luck.

J

Your in deep but fear not, Lord Hippo will give you his blessing.

No one loves FL’s more than him.
Not unusual get this sorta thing after transplant likely seem obvious when you find it

Welcome
and good luck

Welcome to the forum