Forward facing rear seats

This site contains affiliate links for which LandyZone may be compensated if you make a purchase.
D90mitch

D90mitch

Well-Known Member
Posts
2,419
Location
Sometimes Peterborough, Sometimes Hatfield
Have been looking at possibly doing this upgrade, to forward facing rear seats. Would be a shame to go from 6 seats to four but for long journeys those little 'uns in the back aren't much good. I know that exmoor trim make them, but wasn't passionate about having the seatbelt socket attatched to the load floor, I am pretty sure it would do my head in :D . I have seen the newer genuine Land Rover ones and they have the seat belt socket built in on the side. My question is, would new rear seats fit or is the rear tub on newer 90's completely different?
 
I used a transit seatbelt in mine and the anchor has a long stalk. It's attached to the floor but doesn't get in the way at all. I also have the seatbelt clip that can attach directly onto the seat but I doubt that would be as secure
 
I think that the benches in the back of the new Defenders are much smaller than older ones, so I doubt the seats from one of these newer vehicles would fit.
 
D90mitch said:
Have been looking at possibly doing this upgrade, to forward facing rear seats. Would be a shame to go from 6 seats to four but for long journeys those little 'uns in the back aren't much good. I know that exmoor trim make them, but wasn't passionate about having the seatbelt socket attatched to the load floor, I am pretty sure it would do my head in :D . I have seen the newer genuine Land Rover ones and they have the seat belt socket built in on the side. My question is, would new rear seats fit or is the rear tub on newer 90's completely different?
Click to expand...

Seat belts unclip

ede6yqaq.jpg


So your only left with small bracket on the floor
 
I would imagine you could use the rear ones from a disco. Don't they unclip?

Fitted my one side properly. Few adjustments needed. Need a shorter bolt in one spot.

ImageUploadedByTapatalk1365276167.771686.jpgImageUploadedByTapatalk1365276176.738499.jpgImageUploadedByTapatalk1365276189.001878.jpg
 
M10. 2 to bolt plate of seat to per bracket. One through to wheel arch through brackets. One short one into top of the tub per bracket. Two through bottom plate of the seat into wheel arch. Ain't gonna move ever. Sadly i should have put them 30mm further forward as i have gone through the supports under the arches.
 
You must log in or register to reply here.

Similar threads

dag019
Rear storage box
Replies
6
Views
542
kevstar
kevstar
AJ-90TDi
New 90 TDi Owner - let the journey begin
Replies
15
Views
1K
AJ-90TDi
AJ-90TDi
H
Seat back keeps falling forwards
Replies
4
Views
351
Anaconda
A
S
Rear Body Repairs - Best Way Forward?
Replies
6
Views
498
meego
meego
A
Alternative Front Seats?
Replies
12
Views
2K
FlyingPete
FlyingPete
Back
Top