FL1 Td4 2006 Brake Drum

This site contains affiliate links for which LandyZone may be compensated if you make a purchase.

Cobby44

Member
Posts
51
Location
Kings Lynn
I'm giving my Freelander slot of attention as of late & I've recently cured the issue of fish rank in the boot. The brake drums are rusty & I want to clean them up.

What's the best way to do this? Can I do it with them in situe?
 
Wire wheel or cup brush on a drill or grinder should work well, and you could do them in-situ quite easily and effectively but it would probably be better to remove them. That way, you can check the condition of the brakes inside the drum. Also, cleaning and painting would be easier, if you want to go that far.
 
Andyfreelandy, so yes after finding a few possibilities that could be the cause I had to pull the carpets up & take both luggage panels out along with the side windows (fixed). It just happened to be the rear right side window (fixed) has a leak so when I sprayed a hose down the side of the car it was finding a way in & it travel between the shell & the body panels. You won't see it unless you take off the rear side panels. There is a little compartment with a rubber grommit in. The water, over time was increasing & therefore finding it's way into the boot compartment. Driving round corners or over speeddumpts etc will divert this water. I removed the grommit & so far it's worked.
 
Wire wheel or cup brush on a drill or grinder should work well, and you could do them in-situ quite easily and effectively but it would probably be better to remove them. That way, you can check the condition of the brakes inside the drum. Also, cleaning and painting would be easier, if you want to go that far.

Paul99, what paint would you use?
 
I like to watch tutorials like that. Thanks for the help. Does the paint need to be high temp resistant though? Maybe Hammerite Black direct to rust would suffice?
 
Brakes get really hot. That is how they work, converting kinetic energy into (mostly) thermal energy. Standard paints would soften, burn and smoke. It needs high temperature paint. I don't know if I would paint the inside of the drums as Chris did in his video, personally. A lot of people wouldn't even paint the centre section of the drum, where the wheel touches it. Mine has copper grease on that part. That seems to be a LandRover recommendation.
 
Back
Top