Fitting a TD5 galv chassis to my 1989 90

I can get hold of a brand new galvanised TD5 90 chassis for £750, i'm just trying to work out what i need to chop and change to fit my 1989 90. So far I have come up with fuel tank mounts and possibly a different tow bar. I'm currently running a discovery 300TDi mated to an LT77 so would need to get a set of 300 engine mounts and weld them in place too. Are the R380 and Lt77 gearbox mounts the same though? Any thoughts are much appreciated, cheers guys

Harry

tow bar?

Engine mounts, gearbox mounts I think, rad mountings are different, tub mountings on rear crossmember are different and probably some other bits and pieces too. I've got a brand spanking td5 chassis in my garage for my 110 rebuild and those are the things I've noticed but I haven't had a proper comparison of the two chassis side by side so there might be more.

Cheers guys, I hadn't thought of the rad mounts. The difference with the rear tub mounts is that the chassis tabs sit behind the bodywork unlike earlier ones where they are on the outside, I don't think this should be a problem, if needs be i can always cut/adjust/weld.

Does anyone know where I can buy decent (not britpart) engine/gearbox mounts? Busy pricing everything up at the moment