Engine lifting brackets

This site contains affiliate links for which LandyZone may be compensated if you make a purchase.
P38guy said:
O.K, so what would be the best way to remove engine make lifting brackets ? and can engine and gearbox be removed as one unit I have the use of JCB to lift out any advice appreciated thanks
Click to expand...
I'm planning to get the engine and box out of my spares dog in one piece, but I'm not worried if I have to cut the front of the car where the rad went:eek:
 
I have an adjustable lifting frame that goes on the engine crane. You can wind the lifting eye back and forth along it to balance the load or to tilt the load. Very handy piece of kit.
 
i have lifted a few of them engines out some of them have an eye just above the starter and onto the front of the exhaust manifold. that will give a pretty good balance. i lifted one by the 2 manifolds . remove all rads and coolers if the engine sways it cant do harm if they are out of the way . do not use inlet manifold for lifting if it is plastic
 
seanmull said:
i have lifted a few of them engines out some of them have an eye just above the starter and onto the front of the exhaust manifold. that will give a pretty good balance. i lifted one by the 2 manifolds . remove all rads and coolers if the engine sways it cant do harm if they are out of the way . do not use inlet manifold for lifting if it is plastic
Click to expand...

Thanks for the info will give it a go, it's coming out :)
 
You must log in or register to reply here.

Similar threads

jeremy156
L322 4.4 TDV8 cam cover / intake removal
Replies
4
Views
559
jeremy156
jeremy156
E
Hydraulic engine lift
Replies
5
Views
838
Eldon
E
S
what are these brackets for
Replies
6
Views
810
Ric82
Ric82
P
L322 deployable side steps not working
Replies
8
Views
871
gold rover
gold rover
Wimblowdriver
Defender Mudflap Brackets
Replies
0
Views
405
Wimblowdriver
Wimblowdriver
Back
Top