EFi Vucuum pipe from fuel pressure reg. to ?????

T

Total Loss

New Member

Posts

6

Location

Berks/Hants

• Apr 13, 2010

• #1

Where does the vacuum pipe from the from the fuel pressure regulator connect to to get its vacuum ? I have the tube at the back of the engine not connected to anything & I cant see anywhere it could connect to ?

 

1992lse

New Member

Posts

861

Location

ontinyent spain

• Apr 13, 2010

• #2

it plugs into the inlet manifold, at the back, look hard and you will see it

 

T

Total Loss

New Member

Posts

6

Location

Berks/Hants

• Apr 13, 2010

• #3

1992lse said:

it plugs into the inlet manifold, at the back, look hard and you will see it

Click to expand...

I had a good look & feel around the back earlier with no luck, hence the question. If its defiantly at the back I'll have to look harder !

 

T

Total Loss

New Member

Posts

6

Location

Berks/Hants

• Apr 14, 2010

• #4

pics of the intake I've just found
Rover 14CUX Hot Wire Mass Flow EFI: Service and Troubleshooting

 

W

Walshie

New Member

Posts

79

• Apr 16, 2010

• #5

I had the same issue just recently.
Unless you happen to be 7' 6" then you have to either sit on the rad and lie over over the lump to find the small stub that the vacuum pipe fits onto. The other alternative is that you propel your 10 year old son up there and get him to do it. Probably best with a cool lump though! Not only is he smaller but his eyes work properly too!!