EAS Vacuum pipes

This site contains affiliate links for which LandyZone may be compensated if you make a purchase.

magictiny

New Member
Posts
435
Location
Billingshurst, West Sussex
OK I have replaced the two short pipes to the pump and actuator (?) and I have replaced the switch on the brake pedal - I have looked at the long pipe but cannot see and cracks etc. - yet when I take the actuator pipe off and blow down it I can't creat any pressure - therefore surmise that a pipe must still be leaking.

This has to be the long pipe - so two questions.

Where can I buy one from?

How do you swap it over - i.e. get it through the bulk head?
 
Last edited:
OK I have replaced the two short pipes to the pump and actuator (?) and I have replaced the switch on the brake pedal - I have looked at the long pipe but cannot see and cracks etc. - yet when I take the actuator pipe off and blow down it I can't creat any pressure - therefore surmise that a pipe must still be leaking.

This has to be the long pipe - so two questions.

Where can I buy one from?

How do you swap it over - i.e. get it through the bulk head?

Surley you mean cruise control pipes. No vac pipes on EAS. To much vino? Use silicon vac pipes Ebay for little money check id you need.
 
Doh - title changed - thank Wammers

I will check flea bay ;)

Is there an easy way to get the replacement through the bulkhead?

I would try joining old to new with a suitable length of threaded bar to get a good internal grip. And maybe a bit of tape over the joint. Then with a bit of quiet pulling and pushing you should be able to tease them thru.
 
Back
Top