EAS Refurb!!! Story so far!!

This site contains affiliate links for which LandyZone may be compensated if you make a purchase.
R

Rachelkgr

Active Member
Posts
715
Location
Manchester
2001 DHSE

So pump has been serviced.

Today I fitted a new valve block!!!! Pipes all sealed nicely.

Still have an over active pump!!!! Grrrr!!!!!!!

I can hear a bit of valve clicking at a height and a little movement at the front, followed by prelonged pump running.

I wondered whether switching the front height sensors is causing a problem. I did the height calibration after the swop.


She stood on the Motorway height all week without a drop. So I think the bags are ok.......

Foxed!!! :mad:
 
It will run a fair bit until tank is fully pressurised after that it should settle
 
Rachelkgr said:
2001 DHSE

So pump has been serviced.

Today I fitted a new valve block!!!! Pipes all sealed nicely.

Still have an over active pump!!!! Grrrr!!!!!!!

I can hear a bit of valve clicking at a height and a little movement at the front, followed by prelonged pump running.

I wondered whether switching the front height sensors is causing a problem. I did the height calibration after the swop.


She stood on the Motorway height all week without a drop. So I think the bags are ok.......

Foxed!!! :mad:
Click to expand...

Maybe the new valve block has the same problem the old one had. That would maybe down to a ten penny O'ring.
 
Rachelkgr said:
2001 DHSE

So pump has been serviced.

Today I fitted a new valve block!!!! Pipes all sealed nicely.

Still have an over active pump!!!! Grrrr!!!!!!!

I can hear a bit of valve clicking at a height and a little movement at the front, followed by prelonged pump running.

I wondered whether switching the front height sensors is causing a problem. I did the height calibration after the swop.

She stood on the Motorway height all week without a drop. So I think the bags are ok.......

Foxed!!! :mad:
Click to expand...

Erratic readings from a height sensor can cause problems.
 
Thanks all, been for a long run.....Pump seems to have settled, 30 second run after a lift to height.......occasional 10 second burst!! Much much better than it was........
 
Well done Rachel, it's good to see people taking the advice on here and putting it to good use.
You will save your self thousands following Wammers how to do it sections, I have :)
 
You must log in or register to reply here.

Similar threads

JamesBB
P38A EAS again.
2 3
Replies
41
Views
5K
JamesBB
JamesBB
D
L320 suspension query
Replies
6
Views
1K
Graculus
Graculus
I
L322 Stolen recovered / suspension fault / Storey Wilson!
Replies
14
Views
2K
IamSpartacus
I
feyniriel
P38 EAS problems
Replies
18
Views
3K
pwood999
pwood999
M
Disco 3 (LR3) Discovery 3 sagging overnight
Replies
0
Views
651
Matt BB
M
Back
Top