P38A Eas problems

pete12345 · Oct 7, 2018

hi last week I refurbished the eas compressor used the car a couple of times and all was good but this morning the rear bags were taking ages to inflate I tried plugging in the nanocom deflated all the bags then reinflated but now the compressor is running all the time but there's no air at all going into the bags and the car is on the bump stops any help much appreciated as I need to use the car in the morning 4.6 bosh 1999

Nickpen · Oct 7, 2018

Well as you've had the compressor to bits I'd check its air output for a start, check its actually delivering air

pete12345 · Oct 7, 2018

Yer it's been fine through the week parked car for few days and the bags stayed inflated I was thinking could it be a switch that stops it inflating like a door open but I've checked all the doors are closed

Nickpen · Oct 7, 2018

Well that might be, there's the little rubber o ring seal under the metal spring tang, if you replaced that, the screw might have worked loose?

pete12345 · Oct 7, 2018

I didn't replace that rubber ring

pete12345 · Oct 7, 2018

Checked the fuse and relay in fuse box all ok

pete12345 · Oct 7, 2018

Going to bite the bullet bye another compressor mines not putting out enough air am I right in thinking kurtjohnson does them for sale on here sometimes

kds · Oct 7, 2018

pete12345 said:
Going to bite the bullet bye another compressor mines not putting out enough air am I right in thinking kurtjohnson does them for sale on here sometimes

Yes believe so.

P38A Eas problems

pete12345

Well-Known Member

Nickpen

Active Member

pete12345

Well-Known Member

Nickpen

Active Member

pete12345

Well-Known Member

pete12345

Well-Known Member

pete12345

Well-Known Member

kds

Well-Known Member

Similar threads