Eas problem

This site contains affiliate links for which LandyZone may be compensated if you make a purchase.

Smally 1

New Member
Posts
6
Location
Newport
Hi I'm new here and a new range rover owner I have a 4.6 2002 vogue I've just had a problem with eas after a loud pop and hiss on motorway I think I may have located offending leak but just asking is there any airlines for eas running across rear axle ....many thanks in advance
 
Hi I'm new here and a new range rover owner I have a 4.6 2002 vogue I've just had a problem with eas after a loud pop and hiss on motorway I think I may have located offending leak but just asking is there any airlines for eas running across rear axle ....many thanks in advance

Hi there, thanks for joining the worlds No.1 online Land Rover forum :)

If you could direct technical questions to the technical boards for your specified vehicle please and for fu@# sake don't past questions in the members vehicles forum, that's for the Land Rover equivalent of a d!ck pic type thread.

Ta for now.
 
Hi and welcome to the forum:)
4.6 would be a p38 there are air lines that cross the car at the back one goes from the valve block to the air tank, the lines can get melted from an exhaust blow, best to ask in the range rover section , there is also an eas fault finding check procedure in the tech archive, top of range rover section home page

https://www.landyzone.co.uk/forum/range-rover.10/
 
Hi and welcome to the forum:)
4.6 would be a p38 there are air lines that cross the car at the back one goes from the valve block to the air tank, the lines can get melted from an exhaust blow, best to ask in the range rover section , there is also an eas fault finding check procedure in the tech archive, top of range rover section home page

https://www.landyzone.co.uk/forum/range-rover.10/
Many thanks for your answer and time being new I didnt know about different areas I'll look in correct areas now many thanks
 
Welcome to the forum
I7pha4t.jpg
 
All sorted small hole cut out and repaired a simple fix once I had managed to get access and unclip pipe lol.....many thanks for assistance
 
Back
Top