EAS Leak

An EAS update, and a new problem.

Got a new compressor, valve block seal kit, exhaust diaphragm, air dryer and exhaust filter. All fitted, and suspension now goes up and down fine.

Except I've got a leak. Where pipe 6 goes into the valve block, the pipe has a very small split right where the collar thing is. Can I simply chop the end of the pipe off (I think there's enough before the bend)?

yes u can.

burnie said:

yes u can.

Click to expand...

Thanks, burnie. Will give it a go in the morning.

wat did u do with old pump .i need new read mine us cheerssss

burnie said:

wat did u do with old pump .i need new read mine us cheerssss

Click to expand...

Sorry - haven't been on recently...

The original pump is in my garage. It's got what I think is an electrical problem - it runs for 5 or 6 seconds then stops and won't start again. The seal and inlet filter are new, and everything else (non-electrical) appears to be in good nick. It was working fine before the seal went.