EAS-finally got a fault code

stevebrookman

Well-Known Member

Posts

390

• Dec 9, 2012

• #1

Hello all,
Out and about today and the eas finally went into fault mode (afterwaiting 4 months (had to reset it then with my Kicker Lite which doesn't read faults).

Got home and rigged it to the PC.
The fault was 2 "pressure signal constantly high".

Any pointers on how to fix this would be more than welcome.

Steve

 

wammers

No longer with us, RIP

Donater

Posts

58,170

Location

Preston Lancs.

• Dec 9, 2012

• #2

Try cleaning the contacts in the two plugs inside the EAS box. Mainly the one under the valve block. Clean and make and break a few times to get a good contact possible bad contact on two yellow wires from pressure switch.

 

stevebrookman

Well-Known Member

Posts

390

• Dec 9, 2012

• #3

Cheers,
I,ll give it a go and if not change the switch.

Thanks

Steve

 

stevebrookman

Well-Known Member

Posts

390

• Dec 9, 2012

• #4

just had a look at a picture of the pressure switch and I have a spare connected to a driver unit I bought a while ago. Will give contacts a clean and if no good I'll change the driver unit.

Thanks

Steve

 

Datatek

Well-Known Member

Posts

46,080

Location

Near Poitiers SW France

• Dec 9, 2012

• #5

stevebrookman said:

just had a look at a picture of the pressure switch and I have a spare connected to a driver unit I bought a while ago. Will give contacts a clean and if no good I'll change the driver unit.

Thanks

Steve

Click to expand...

I would not change the driver unit, you might just introduce another problem. It may just be a dodgy switch, a bad connection or an aberration.

 

stevebrookman

Well-Known Member

Posts

390

• Dec 9, 2012

• #6

Will do.
Thanks Keith