P38A EAS driver pack

Baileyroverq · Oct 24, 2016

Hi All
I have checked the eas for leaks both valve block and compressor with the soapy water have had the new o rings installed and that is not leaking still getting Faults saying R/F sensor out of Range could this be the driver Pack and if so Is the part No ANR3900 the right part for a 1997 MY 4.6 hse as I have found a new one for £149 but they say it only fits from 1999 MY but everyone else gives the standard 94-02 any ideas as always much appreciated for any help offered

RubyRR · Oct 24, 2016

R/F do you mean Right Front height sensor?

wammers · Oct 24, 2016

I would be looking at R/F sensor. Driver pack is only a slave of the ECU. It can cause problems but a sensor out of range is not one of them.

Baileyroverq · Oct 24, 2016

Hi
Sorry forgot to add it was a brand new R/F height sensor put on a week ago because of the message "R/F out of range"

RubyRR · Oct 24, 2016

Was the new sensor calibrated?

pwood999 · Oct 24, 2016

Do you have the Nanocom readings for all the heights before & after changing the sensor ?

How did you check the bottom valves with soapy water ?? Only way I have found to do this, is to pressurise the Valve Block on the bench but upside down so I can see the bottom valves. I also use a few feet of airline fitted between F/L to F/R and R/L to R/R to create an air circuit for leak testing. Same thing for dryer loop. Finally I use pressure test feeding each valve to simulate whether it can hold bag pressure.

oakey · Oct 24, 2016

Maybe the contacts for your front right sensor are mucky. Try disconnecting and spraying with contact cleaner and then recalibrate

Grrrrrr · Oct 24, 2016

GBurnham isn't far from Heathrow ....

pwood999 · Oct 24, 2016

Grrrrrr said:
GBurnham isn't far from Heathrow ....

already suggested that on the other EAS thread !!

Baileyroverq · Oct 25, 2016

Hi as usual loads of suggestions thanks for that and sorry for delay getting back I only did the soapy water test on the bags and block , I calibrated with eas software everything went fine then the fault appeared I will give it a go trying to clean the contacts on the sensor I have the settings for before and after calibration but they are at home so will post them when I get back later tonight

P38A EAS driver pack

Baileyroverq

Active Member

RubyRR

Member

wammers

No longer with us, RIP

Baileyroverq

Active Member

RubyRR

Member

pwood999

Well-Known Member

oakey

Well-Known Member

Grrrrrr

Technician, Bodgit & Scarper Ltd

pwood999

Well-Known Member

Baileyroverq

Active Member

Similar threads