nathan5346
Well-Known Member
- Posts
- 11,939
- Location
- oldbury
Me mates 97 dse is having probs starting, he says the glow light no longer comes on, it starts eventually but approaches flat'nin the battery.. any ideas?
dse non starter
- Thread starter nathan5346
- Start date
This site contains affiliate links for which LandyZone may be compensated if you make a purchase.
Datatek
Well-Known Member
- Posts
- 45,013
- Location
- Near Poitiers SW France
Engine temperature sensor failure, glowplug relay failure or connections, fuse, fuse box connections just for starters.
nathan5346
Well-Known Member
- Posts
- 11,939
- Location
- oldbury
least its a start 
ta
ta
Datatek
Well-Known Member
- Posts
- 45,013
- Location
- Near Poitiers SW France
least its a start
ta
Glow plug relay's are a common failure point on many makes of vehicle, I don't have enough experience of the P38 to know if it common to the P38 too, but it probably is. I have dealt with recent failures on my excavator, a Renault Tractor with Deutz engine and a Hyundai Galloper
nathan5346
Well-Known Member
- Posts
- 11,939
- Location
- oldbury
i advised him to check relays fuses and connections thort it worth an ask on ere to see if theres any common ones,i'll let ya know how he gets on
- Posts
- 58,170
- Location
- Preston Lancs.
Check fuses and relay for heater plugs. Light not coming on could of course just be a blown bulb, but i think the fact that system does not appear to work, hence no start, precludes this. More likely to be relay problem.
nathan5346
Well-Known Member
- Posts
- 11,939
- Location
- oldbury
checked and swapped relays over etc, no glow lite at all and wont start, when turning over the glow light comes on internitantly
- Posts
- 58,170
- Location
- Preston Lancs.
Take a look at the heater plug ECM inside the plastic box next to battery, make sure every connection is clean and tidy. If that appears ok try changing the water temp sensor for the ECU.
pandy7203
New Member
- Posts
- 332
- Location
- rowley regus
wheres the water temp sensor?
pandy7203
New Member
- Posts
- 332
- Location
- rowley regus
im andy btw, nathans mate who's mota it is, gonna fone the aa but i wont hold my breath
nathan5346
Well-Known Member
- Posts
- 11,939
- Location
- oldbury
believe it not.... air was in fuel the pipe after the filter.. we changed the filter still the same tank was 1/4 full so filled tank up and its all ok no air in fuel pipe, the glow plug light still dont come on but it starts as it shud... any reason why air would be there on 1/4 but not when over 1/2 full?
- Posts
- 58,170
- Location
- Preston Lancs.
Pickup pipe?
pandy7203
New Member
- Posts
- 332
- Location
- rowley regus
what and where is the pickup pipe?
- Posts
- 58,170
- Location
- Preston Lancs.
what and where is the pickup pipe?
Attached to the pump inside the tank. Sounds as though there is a split in it part way up. The pump will be pumping fuel through it then with low tank when the pump stops air is being drawn in. When the tank is full the only thing it can draw in is fuel because the split is covered.
pandy7203
New Member
- Posts
- 332
- Location
- rowley regus
oh right, thanks for that... nothing to worry about then? till it goes altogrther?
Derek Ward
Active Member
- Posts
- 798
Just keep it well above 1/4. You'll find it drives below that as the fuel will slosh about covering the split. When you stop, the split is exposed and no start.
