Driveshaft too short - Help please

Sroley · Nov 30, 2019

Hello!

I’ve replaced my swivel housing, disc, and bearings and once all the hub elements are reassembled there is not enough space for the circlip to be fitted (see photos below). The stub Axel is fitted tightly, the bearings are also fitted tightly.

Any suggestions would be very helpful

neilly · Nov 30, 2019

Take one of the drive member bolts/ or get a similar one, does not have to be perfect, screw / push it into the threaded hole in the end of the shaft and pull it out.

fit circlip.

Cheers

Scooby22 · Nov 30, 2019

Have a look at this. About 46 minutes in it shows Mike pulling his shaft out. Dirty boy

Sroley · Nov 30, 2019

P

neilly said:
Take one of the drive member bolts/ or get a similar one, does not have to be perfect, screw / push it into the threaded hole in the end of the shaft and pull it out.

fit circlip.

Cheers

Thanks so much!!

Sroley · Nov 30, 2019

Scooby22 said:
Have a look at this. About 46 minutes in it shows Mike pulling his shaft out. Dirty boy

Fantastic! Thanks!

Driveshaft too short - Help please

Sroley

Member

Attachments

neilly

Well-Known Member

Scooby22

Well-Known Member

Sroley

Member

Sroley

Member

Similar threads