Driver's footwell rust

This site contains affiliate links for which LandyZone may be compensated if you make a purchase.

AndrewFoxPitt

New Member
Posts
7
Location
London
Hello everybody

My Defender's got a fair bit of rust in the driver's footwell. Picture attached.

Does anybody have any advice as to the best course of action to remedy it?

Thanks
 

Attachments

  • 20190430_143845.jpg
    20190430_143845.jpg
    198.2 KB · Views: 242
  • image.png
    image.png
    14.3 KB · Views: 221
Welcome:)

Eh yes that needs sorting, look at some of the guys build threads and you will find many solutions.
I gratefully don’t have that problem:) (yet:eek:)

Think a lot of the guys like YRM for repair panels https://yrmit.co.uk/yrm-parts/ I think, but I have never used.

Are you going to diy?

You could always get some rubber mats;)

Any pics of the shiney side:) that’s really what this section is for.

J
 
Last edited:
Take the floor plate out and cut back the rusty bit to a good bit and weld in a plate. If it is up the sides as well, you can get the whole footwell from Paddocks.
 
I would replace the entire footwell. They are not very expensive and will save a lot of time mucking about with your choice of cutter. Patching up will only be temporary.

Col
 
Back
Top