smurphy
Active Member
- Posts
- 410
- Location
- The Potteries (Land of the Gods)
Does the rear corner panel come off on the disco 1 as ive reversed into a post and seen one been broke the same colour as mine. Thanks Steve.
Does it come off?
- Thread starter smurphy
- Start date
This site contains affiliate links for which LandyZone may be compensated if you make a purchase.
Pikey
Dummy Ejection Facilitator..
- Posts
- 47,185
- Location
- in Baron Wet Bum's Slave pit..
FFS do a search!! yu lazy fooker 
We did that yesterday???
We did that yesterday???smurphy
Active Member
- Posts
- 410
- Location
- The Potteries (Land of the Gods)
FFS do a search!! yu lazy fooker
I read that yesterday but i was asking about the very rear panel or does that come off with it? Thanks for the reply RD
P.S. I am lazy too
Pikey
Dummy Ejection Facilitator..
- Posts
- 47,185
- Location
- in Baron Wet Bum's Slave pit..
Nope. The whole rear corner & side skin has to come off
smurphy
Active Member
- Posts
- 410
- Location
- The Potteries (Land of the Gods)
So I have to replace the rear quarter as well then sorry just a bit thick you see and thanks again RD
Pikey
Dummy Ejection Facilitator..
- Posts
- 47,185
- Location
- in Baron Wet Bum's Slave pit..
Ye whole side has to be replaced. I've heard of peeps using a recip saw to cut the corner off & Panel seal the replacement corner on.
smurphy
Active Member
- Posts
- 410
- Location
- The Potteries (Land of the Gods)
I ask for the whole thing then cheers
iannotts
New Member
- Posts
- 4,401
- Location
- East midlands,
do you mean the corner panel with the light in?
that does come off sererately
that does come off sererately
Pikey
Dummy Ejection Facilitator..
- Posts
- 47,185
- Location
- in Baron Wet Bum's Slave pit..
Fooking dunt. I was after one for me 200 disco & I couldn't find one anywhere was told be loads of peeps you gotta replace the fooking lot. Microcat even shows it as a full panel.
iannotts
New Member
- Posts
- 4,401
- Location
- East midlands,
smurphy
Active Member
- Posts
- 410
- Location
- The Potteries (Land of the Gods)
Yer I do and hope does would be easier for me.
Pikey
Dummy Ejection Facilitator..
- Posts
- 47,185
- Location
- in Baron Wet Bum's Slave pit..
There is but parrently the fookers spot welded to the side panel. Like I sed, a few peeps have run an air saw down the joint and then Panel sealed the replacement on but it int designed to come orf.
Richard Martin
Well-Known Member
- Posts
- 1,371
- Location
- Cardiff
Rave says they are spot welded together. It says you can cut the panel with the lights off and then use nuts and bolts to join the replacement to the one you are keeping, but seeing as you have to take both off to get that far you may as well just replace both
