Dr_evil
Banned
- Posts
- 29,535
- Location
- Perched on the naughty step
Homemade from 5mm steel plate, 6mm steel chassis mounts and box section reinforcements. It bolts directly to the old bumper mounts.
Looking to sell for the cost of the materials used as I fancy making a slightly larger one
The bottom section with the bash plate can be cut off as its not structural, the front piece is 10mm thick and its built like a brick ****house
To explain the winch/non winch part of the title, I have left the front section intact as I hadn't decided which winch I was going to fit so the idea was to simply measure up and cut in the rectangular hole with a plasma cutter or angle grinder then bolt or weld the fairlead roller into place.
Anyway £80 collected, its fully black with a few coats of Hammerite and a numberplate fits on to the side easily, I just glued mine on with Tigerseal
Looking to sell for the cost of the materials used as I fancy making a slightly larger one
The bottom section with the bash plate can be cut off as its not structural, the front piece is 10mm thick
and its built like a brick ****houseTo explain the winch/non winch part of the title, I have left the front section intact as I hadn't decided which winch I was going to fit so the idea was to simply measure up and cut in the rectangular hole with a plasma cutter or angle grinder then bolt or weld the fairlead roller into place.
Anyway £80 collected, its fully black with a few coats of Hammerite and a numberplate fits on to the side easily, I just glued mine on with Tigerseal
