disco 300 tdi conversion

andytrayback · Aug 6, 2012

hi all new to the site just been reading the posts on here and just wondered if the 2.5td loom needs any modifications for a disco 300tdi coversion into a 90 if so could anyone tell me what? cheers andy

ferretboy · Aug 6, 2012

welcome you will need the (ecu) and all the bundles of wire a fuel pump etc its easy but you will need many bits and unless you are very good at vehicle electrics a sparky too !!!!

andytrayback · Aug 6, 2012

hi thanks for the advise there was a thread on here that said there was only minor alteration to it just wondered wot cheers andy

andytrayback · Aug 6, 2012

oh and it doesnt have an ecu

andytrayback · Aug 7, 2012

anyone got any suggestions?

Pikey · Aug 7, 2012

andytrayback said:
anyone got any suggestions?

Stick to one thread per question and be a little less impatient. :doh:

1spin · Aug 7, 2012

andytrayback said:
oh and it doesnt have an ecu

well then its easy init..... feed for glow plugs, and relay. the rest you have. you may have to extend some wires etc.

andytrayback · Aug 7, 2012

thanks for the advce

andytrayback · Aug 7, 2012

i dont mean seem impatient but after a while ur post gets pushed down the pages and nobody reads them and i need to get the old girl back on the road

disco 300 tdi conversion

andytrayback

New Member

ferretboy

Active Member

andytrayback

New Member

andytrayback

New Member

andytrayback

New Member

Pikey

Dummy Ejection Facilitator..

1spin

New Member

andytrayback

New Member

andytrayback

New Member

Similar threads