Apoole1401
New Member
- Posts
- 1
- Location
- Studley
Hiya not sure if anyone can help but would be much appreciated.
Disco 2 10p engine
-New head gasket
-New cylinder head & piston rings
-New air bleed valve and return valve
-New fuel filter
-New fuel regulator & seals
-Also fitted new fuel injector copper washers and seals no leaking anywhere once on priming so all good that end (Genuine)
Injectors are all in the right location numbers noted when taken out.
-New harness
-crank shaft sensor is working according to please see below picture of reading
Will prime the system. Once started will run a dream for a couple minutes and then die. Then back to priming for ages for it to start again for this to happen again so there’s an issue with the fuel somewhere.
was running fine before I fitted head gasket.
Next step is to buy a fuel pump but can’t see why that would just stop when it was working perfectly before hand.
Also fuel pump isn’t screaming as people have asked everything is working as it should. Went over all work to check pipes for location going off pictures I took before carrying out the work so everything is correct.
if anyone can help be much appreciated !
Disco 2 10p engine
-New head gasket
-New cylinder head & piston rings
-New air bleed valve and return valve
-New fuel filter
-New fuel regulator & seals
-Also fitted new fuel injector copper washers and seals no leaking anywhere once on priming so all good that end (Genuine)
Injectors are all in the right location numbers noted when taken out.
-New harness
-crank shaft sensor is working according to please see below picture of reading
Will prime the system. Once started will run a dream for a couple minutes and then die. Then back to priming for ages for it to start again for this to happen again so there’s an issue with the fuel somewhere.
was running fine before I fitted head gasket.
Next step is to buy a fuel pump but can’t see why that would just stop when it was working perfectly before hand.
Also fuel pump isn’t screaming as people have asked everything is working as it should. Went over all work to check pipes for location going off pictures I took before carrying out the work so everything is correct.
if anyone can help be much appreciated !
