Dimension needed!

panospylar · Apr 8, 2025

Hi Chaps,

I am and will be away from my landy for some weeks but during this time i’m working on a dash design that i’d like to 3d print.

Would any of you with easy access to your car be so kind as to provide the dimension indicated in the attached picture? Basically from the notional centre of the dash/windshield (or the centre of the aux panel if your car is equipped with it) right to the edge of the standard instrument panel.

Thanking you all in advance.

Kind regards,
Panos

Moorhouse2 · Apr 10, 2025

On my 1982 the measurement will vary depending on whether you measure to the top or the bottom of the instrument panel as it wider at the bottom than at the top. (ie its a trapezoid not a rectangle) Measurement from centre of aux panel to top corner of instrument panel is 65cm, to the bottom corner of the instrument panel is 66cm. Suspect there might be a fair bit of variation between vehicles though as the face of the instrument panel can move a bit on the locating screws when refitting after rewiring etc. Hope this helps

panospylar · Apr 10, 2025

That is extreme

Moorhouse2 said:
On my 1982 the measurement will vary depending on whether you measure to the top or the bottom of the instrument panel as it wider at the bottom than at the top. (ie its a trapezoid not a rectangle) Measurement from centre of aux panel to top corner of instrument panel is 65cm, to the bottom corner of the instrument panel is 66cm. Suspect there might be a fair bit of variation between vehicles though as the face of the instrument panel can move a bit on the locating screws when refitting after rewiring etc. Hope this helps

That’s extremely helpful, thank you!

Best,
Panos

Dimension needed!

panospylar

New Member

Attachments

Moorhouse2

Active Member

panospylar

New Member

Similar threads