- Posts
- 2,145
- Location
- East of England, UK
Does anyone know what the resistance should be for Defender front ABS sensors?
Defender Td5 ABS Sensor Resistance
- Thread starter tom1979
- Start date
This site contains affiliate links for which LandyZone may be compensated if you make a purchase.
Flossie
Well-Known Member
- Posts
- 11,049
- Location
- Shropshire
Nope, but on a p38 they are all the same or should be, so a sensor reading different to the rest is the faulty one. Dunno if that helps?
JUKE179r
Well-Known Member
- Posts
- 3,166
- Location
- Suffolkshire
I know you are asking for a Defender but on a Disco 2 the resistance across the 2 ABS disconnected pins should be 950-1100 ohms and when connected they all read between 2 - 2.3VAC.
Flossie
Well-Known Member
- Posts
- 11,049
- Location
- Shropshire
Same as a p38 then
- Posts
- 2,145
- Location
- East of England, UK
You would hope so as they share the same hubs.Same as a p38 then
Yes I had seen that in Rave for the D2, but there is nothing for the Defender. They are not the same sensor, or even the same design, so not sure if the values would be the same or not, was hoping someone would know. I will just get new, and see.