Defender rear diff clonks?

This site contains affiliate links for which LandyZone may be compensated if you make a purchase.

gary brion

Active Member
Posts
167
Location
piddington bucks
Hi All,
I have a 110 td5 05 Hicap
massive clonks coming from the rear diff, what will I need a complete new diff?
If so where is the best place to get a good one? any pointers you may think I need to know?
Thanks
 
I would Check the drive flanges first before pulling the diff apart. They wear down and get a lot of play. They are also cheap And easy to change. You may find that you just have a little
Slack in everything rather than a catastrophic diff failure.
 
check drive flanges and half shaft splines both ends but more than likely wheel end ,check prop ujs, if diff may just need adjusting back lash but while your in the diff you will be able to check condition of teeth also could be a brake sticking on
 
I have checked the A-frame, looks pretty tight, typically let the clutch up and an almighty bang and if parked on a hill it locks up
If that helps?
If you take the handbrake off does the motor move ? (Before you let the clutch off)

does it make this noise if you are parked on flat/level ground after the handbrake has been applied?
 
It does sound as if the hand brake is holding on some. What happens is as you move along no clonk but as soon as clutch goes in the drag of the hand brake is enough to put pressure on the drive train and take up the usual slack in an instant hence the clonk. When starting off its the other way, hand brake still holding some and suddenly let's go.
A hot drum after driving a symptom. A good clean out and new expander and shoes/springs will sort.
 
Back
Top