defender bulk head
- Thread starter steve-c
- Start date
This site contains affiliate links for which LandyZone may be compensated if you make a purchase.
bustersbus
Well-Known Member
- Posts
- 13,755
- Location
- Near Dumfries, Scotland
Aye it will with some mods... fillin' holes cuttin' the wiper motor bracket off, drillin' holes and stickin' some rivnuts in.
Ye might want to try a search on here as it's bin covered a few times before
CROWBLIND
Active Member
- Posts
- 198
Where abouts are you based?
TD5 Bulkhead will fit no prob, but you will need to cut a hole for the wiring loom behind the fuse box and also bung a few up. Bonnet pull is different to, i made a beacket to fit the old bonnet pull, but i suppose you could use the td5 item, but mine didnt have one.
I know a landy breaker just north of brum, mine cost 95 quid. Allow plenty of time to swap as it is a bit of a time consuming job to say the least. Good luck
TD5 Bulkhead will fit no prob, but you will need to cut a hole for the wiring loom behind the fuse box and also bung a few up. Bonnet pull is different to, i made a beacket to fit the old bonnet pull, but i suppose you could use the td5 item, but mine didnt have one.
I know a landy breaker just north of brum, mine cost 95 quid. Allow plenty of time to swap as it is a bit of a time consuming job to say the least. Good luck
