Finally got everything off this and would like it out of my shed.
After spending a couple of hours with an angle grinder and wire brush wheel I have decided that with some welding and a new crossmember that it would make a good chassis for someone.
The back 1/3 of the chassis has a few holes in, hopefully as can be seen in the pics. There is also a small hole on the side, and on the corner of the strengthener for the outrigger. The outriggers themselves are solid.
It has been patched on the bottom of the rails in the past. Nice clean job though.
I will cut out the chassis number, so that will also need welding up.
Mud flaps are free with the chassis!
Not sure how much it is worth, make me an offer. I will leave it on here a couple of days, then put it on ebay.
Just a couple of pics:
After spending a couple of hours with an angle grinder and wire brush wheel I have decided that with some welding and a new crossmember that it would make a good chassis for someone.
The back 1/3 of the chassis has a few holes in, hopefully as can be seen in the pics. There is also a small hole on the side, and on the corner of the strengthener for the outrigger. The outriggers themselves are solid.
It has been patched on the bottom of the rails in the past. Nice clean job though.
I will cut out the chassis number, so that will also need welding up.
Mud flaps are free with the chassis!
Not sure how much it is worth, make me an offer. I will leave it on here a couple of days, then put it on ebay.
Just a couple of pics:
