defender 200tdi temp. gauge

marwell · Apr 11, 2010

hi guys yesterday i changed the bulb of my temperature gauge on my ninety and when i fitted back the dash i switched on the lights and all worked fine. after a while i switched the ignition and the tempretaure guage needle went straight up all the way to the red zone...any ideas of what the problem is? before replacing the bulb the gauge worked fine....

fanatic · Apr 11, 2010

sensing wire rubbed through or shorted to earth-possibly

marwell · Apr 12, 2010

al wirings are fitted in place and there are no shorts can it be the sensor ??

steve bain · Apr 12, 2010

feed wire definately shorting out to earth. have you tested it with multimeter to check for short?

marwell · Apr 14, 2010

multimeter checked the wirings everything is fine...when i remove the connector from the sender the gauge needle goes down so i am going to get a new sensor/sender tomorrow to try to figure it out

rogerboy · May 30, 2016

marwell said:
multimeter checked the wirings everything is fine...when i remove the connector from the sender the gauge needle goes down so i am going to get a new sensor/sender tomorrow to try to figure it out

so what was the end result?

Needalandy · May 30, 2016

I had the same problem a couple of weeks ago on my 200tdi. I replaced the sender but it was actually the gauge that was goosed.

rogerboy · May 31, 2016

Needalandy said:
I had the same problem a couple of weeks ago on my 200tdi. I replaced the sender but it was actually the gauge that was goosed.

I have replaced censor switch and gauge and still showing fully in red

skint-as-usual · May 31, 2016

marwell said:
multimeter ....so i am going to get a new sensor/sender tomorrow to try to figure it out

did that work then ??

rogerboy · May 31, 2016

skint-as-usual said:
did that work then ??

That's what I asked,the post was over a month ago,I have the same problem I have renewed both that's why I asked

skint-as-usual · May 31, 2016

rogerboy said:
That's what I asked,...,I have the same problem

Ah well we await the same response then (cured or not cured)

flat · Jun 1, 2016

If you have replaced sensor and gauge then it's either a) wiring issue of b) your engine is actually overheating.....

rogerboy · Jun 1, 2016

flat said:
If you have replaced sensor and gauge then it's either a) wiring issue of b) your engine is actually overheating.....

Yes must be a wiring issue

defender 200tdi temp. gauge

marwell

Member

fanatic

RESPECT IS EARNED, BEATINGS ARE FREE ;-)

marwell

Member

steve bain

New Member

marwell

Member

rogerboy

Member

Needalandy

Active Member

rogerboy

Member

skint-as-usual

Not a well Known Member - with no likes

rogerboy

Member

skint-as-usual

Not a well Known Member - with no likes

flat

Well-Known Member

rogerboy

Member

Similar threads