Hoping someone might be able to advise. Having just replaced the rear wiper arm & blade (all standard, but a bit more of a bugger than I was anticipating!), I thought I would replace the front blades too. I presumed they would be standard, but they aren’t. Has anyone seen these before (photo attached), and know what they are? The blade appears to attach to a central metal slug in the middle of the attachment, which then pushes onto the arm from the end. Grateful for any advice[GALLERY=][GALLERY=][GALLERY=][GALLERY=][/GALLERY][/GALLERY][/GALLERY][/GALLERY]
D2 non-standard wiper blades - any clue?
- Thread starter Delilah
- Start date
This site contains affiliate links for which LandyZone may be compensated if you make a purchase.
That is very kind of you - thank you. Saves me going back to Rimmer Bros & telling them they’ve mis-advertised! You wouldn’t happen to know what the optimum in length for the front blades are do you - I’ve managed to get myself lost in a forum that ranges from 16-21 inches - which is quite an array!
Hi Delilah
Slight correction. The standard size is 18inch for both front blades and 13 inch for the rear one
But as I said you can go upto 21 inch for drivers front and 19 inch for passenger front if you want the maximum swept area,
Your choice,
Slight correction. The standard size is 18inch for both front blades and 13 inch for the rear one
But as I said you can go upto 21 inch for drivers front and 19 inch for passenger front if you want the maximum swept area,
Your choice,
this has proven to be a slight pain in the arse! having ordered the bosch aerotwin, it would appear that none of the 4 supplied adaptors fit into the wirper balde arms. In fairness, D2 is not marked as compatible, so my fault for ingnoring that minor detail. I think I have found the right replacement on ebay, but I'm not convinced its as good a quality as the Bosch. So my question is, has anyone found a work around to get the non-standard, non-compatible Bosch to fit to the standard wiper arms of the D2?
