D1 bonnet mystery

This site contains affiliate links for which LandyZone may be compensated if you make a purchase.
DaveRRC

DaveRRC

Member
Posts
28
Location
Devon
I have a 1992 two door D1. It’s had the bonnet replaced with a later bonnet. The panel gaps either side of the bonnet are noticeably big! It’s as if early D1 bonnets were wider. Is that right? Or is there something wrong with my car… it’s not been written off and I’m sure it’s not been in an accident.
Any thoughts would be welcome 👍
 
Measure the bonnet across at certain point, (themselves measured from say the front edge), put them up on here, along with the gap measured between both wings, then we can compare.

These plus pics would help us help you.;)
 
The front wings being adjustable seems to be the answer. I think I was just wondering if early D1’s had a different bonnet.

Thanks for your help everyone. Maybe lay off the estrogen though 🤣👍👍
 
DaveRRC said:
I have a 1992 two door D1. It’s had the bonnet replaced with a later bonnet. The panel gaps either side of the bonnet are noticeably big! It’s as if early D1 bonnets were wider. Is that right? Or is there something wrong with my car… it’s not been written off and I’m sure it’s not been in an accident.
Any thoughts would be welcome 👍
Click to expand...
There's only one bonnet that fits all the D1s so both the 200 & 300 series.
The adjustment points are just the hinges and the bonnet catch.
My D1 has a gap along the sides, I can see a part of each wing retaining screw something you don't see on the RRc. :)
 
discool said:
There's only one bonnet that fits all the D1s so both the 200 & 300 series.
The adjustment points are just the hinges and the bonnet catch.
My D1 has a gap along the sides, I can see a part of each wing retaining screw something you don't see on the RRc. :)
Click to expand...
Thanks @discool
That answers my question about the bonnet being the same for the 200 & 300 series. I think some people are suggesting that you can adjust the wing by loosening the wing retaining screws.
 
DaveRRC said:
Thanks @discool
That answers my question about the bonnet being the same for the 200 & 300 series. I think some people are suggesting that you can adjust the wing by loosening the wing retaining screws.
Click to expand...
Thats not by design as the outer wing screws to the inner wing. Maybe a couple millimetres in the size of the fixing screw the wing nothing more, but then my discos bodywork is as it left the factory.
 
You must log in or register to reply here.

Similar threads

G
Stupid D1 noise under load.
2
Replies
29
Views
2K
gsx130
G
S
Hello from New Jersey, USA
Replies
3
Views
567
JUKE179r
JUKE179r
G
D1 door seals
Replies
4
Views
400
guzzi lemans
G
P
2006 Land Rover Defender 110 - Power Steering Failed, something ‘sheered’ off !!
Replies
3
Views
339
PaulDavidThomas
P
Neptune1922
Disco 2 At the moment following a new chassis on Feb 1st I now have quiescent problem.
Replies
7
Views
433
Neptune1922
Neptune1922
Back
Top