clutch pedal

D90mitch · Feb 16, 2015

So, recently I had the clutch master cylinder changed at a garage with a nice TRW one, not cheap crap. However, now the pedal travels about 1/3 of the way down or so before there is any pressure! I took the plate of the pedal box to see where it's positioned but it's right at the end of the thread so can't bring it back any further. Not sure what to do. Told its been bled.

Cheers.

Marmaduke · Feb 17, 2015

If it's travelling like that then I would re bleed it

james6546 · Feb 17, 2015

Marmaduke said:
If it's travelling like that then I would re bleed it

+1, sounds like it still has air in it

D90mitch · Feb 17, 2015

Ok, bleed at the other end from the slave or at the master?

Marmaduke · Feb 17, 2015

Bleed as usual from the slave cylinder but use something to hold the pedal down before you tighten up the bleed nipple as this stops it pulling any air back in when the pedal is released

D90mitch · Feb 17, 2015

Marmaduke said:
Bleed as usual from the slave cylinder but use something to hold the pedal down before you tighten up the bleed nipple as this stops it pulling any air back in when the pedal is released

Yup same as always then. I hate bleeding hydraulic systems -.-

clutch pedal

D90mitch

Well-Known Member

Marmaduke

Well-Known Member

james6546

Well-Known Member

D90mitch

Well-Known Member

Marmaduke

Well-Known Member

D90mitch

Well-Known Member

Similar threads