P38A Clicking when TRYING to start

This site contains affiliate links for which LandyZone may be compensated if you make a purchase.
Clicking when trying to start could be relay 16 failed. Or starter pre engaging but not making contact to close main circuit. The brass bar that the solenoid uses to engage the starter sometimes gets hot and deforms losing contact with the main terminals.
 
Well the plot thinkers. Just tried with the other key and in position 1 all the dashboard lights came on nice and strong as they do, but when I turned it to position 2... as dim as heck. She still started to click In position 3 though.

Also this time for time she wouldn't lock with the fob and then the alarm started! Then it stopped by pressing the unlock on the fob.

Stranger still, as I opened my door she locked all the doors! When I closed the door she then unlocked them. I then used the close on the fob and, hey presto, she locked ok.
 
wammers said:
The contacts under switches are sealed cannot see how contact cleaner would help. Under the plastic switch are two triangular pop contacts. One for each function. Both are sealed in place by clear tape. Contact cleaner cannot get to them. There are three contact points for the outer edges of the triangular contact and one in the middle that is made when the switch is pressed. That completes the circuit. The clear tape must be removed before the contacts can be cleaned. You cut off the seven pips on the reverse of the board to remove the switches. Then cut away the tape switch by switch and remove it complete with contacts stuck to it. Carefully remove contacts from tape clean pop contact and contacts on board. Position pop contact correctly then secure in place with double sided clear tape. Push switch tangs back through board and press switch base onto double sided tape to secure. There is no need to remelt the cut off tangs.
Click to expand...

Never had it apart but doesn't mean one of the previous 8 owners didn't!
 
It's the 6 months down the line when you go to clean the inside of the windscreen and you think to yourself Ok, time to clean the screen, I'll just catch that little nugget with me wet wipe and your still trying to de-smear 2 hours later!
Moral=Think before a flick!!!

ok, maybe time to stop this, I'm getting the boke:(:eek:
 
Grrrrrr said:
Never had it apart but doesn't mean one of the previous 8 owners didn't!
Click to expand...

The pop contacts are held in place by clear tape, they are sealed, nothing can get to them until the tape is removed. They cannot be assembled without tape to hold them in position.
 
Sounds to me like a number of unrelated problems that just seem related. Don't assume the car battery and the fob are ok, try replacing the battery for a known good one and replace the fob battery for a new one. Always try the cheapest and easiest things first.

Col
 
You must log in or register to reply here.

Similar threads

awkwardbob
L322 2003 remote locking locked !
Replies
1
Views
311
kds
K
I
L322 Range Rover 2005 - rear doors, tailgate, fuel cap locked
Replies
1
Views
543
pwood999
pwood999
HillbillyDave
Central locking help
Replies
1
Views
267
Alteredtech
Alteredtech
J
Discovery 2 central locking not working
Replies
6
Views
666
Jack02014
J
M
Rear door lock barrel HELP!
Replies
0
Views
283
Mogardener
M
Back
Top