Can't get it in.....

This site contains affiliate links for which LandyZone may be compensated if you make a purchase.
Beneagles

Beneagles

Well-Known Member
Full Member
Posts
6,407
Location
North Perthshire
Yeah, yeah...clean up your minds....is the 200tdi that I can't get in. 11 bolts lined up with 11 holes...almost through the gearbox half of the bellhousing...but not quite...I guess it must be the drive shaft that is catching, but have checked clutch alignment three times.... any clues? hints? cheers...
 
How'd it go? I can't offer any advice (sorry) but if you've sussed out what the problem was, I'm sure it'll be useful to know when I do my conversion next month!

- Ian
 
After a week of enforced inactivity, I finally got hold of the engine hoist this morning. Gave the Beast a severe talking to, attached the two chains...lifted the engine...and slotted it straight in! :doh: Hey ho....
 
You must log in or register to reply here.

Similar threads

P
Is it always like this ?
Replies
7
Views
423
Kev12
Kev12
M
Discovery1 lt230 in place of LT230R from a 12D?
Replies
3
Views
875
MrF
M
M
Land rover series 3 clutch/gearbox issue, I just can't get it in gear
Replies
7
Views
2K
tottot
tottot
ChrisBduck
3.6L Land rover 90
Replies
2
Views
987
ChrisBduck
ChrisBduck
J
300 Tdi Engine back in, nearly - Story and at the end Questions
Replies
0
Views
741
jer_300Tdi_90
J
Back
Top