Can I fit a Bulkhead in Position without Doors?

This site contains affiliate links for which LandyZone may be compensated if you make a purchase.
N

New2s3landy

New Member
Posts
7
Good afternoon all,

Is it possible to position and fit a Bulkhead (series 3 SWB) without any doors for reference as I don’t have any yet?
(if anyone has a good set of bottoms and tops give me a shout out)

I have read something about having a 34.5” gap as a reference but don’t know if it’s best with a door?

I have the tub for the rear so can use that as a start, any help or advice appreciated

Thanks
 
Listen to codfather79…hard learned experience by the sound of it. I did that once and then spent a lot of time readjusting…and going over my life choices around land rovers. My 90 is 5mm longer on the right side from the left so this was fun to put back together🤬
 
Forrest Gump said:
Listen to codfather79…hard learned experience by the sound of it. I did that once and then spent a lot of time readjusting…and going over my life choices around land rovers. My 90 is 5mm longer on the right side from the left so this was fun to put back together🤬
Click to expand...

Had to adjust just about every single item.
Never, ever fit anything tight. Roof, side frames, tubs, wings bulkheads etc before checking everything lines up.

We live and learn 🤔🙄
 
As above, fit with no washers. And don't tighten. Then add washers when your are doing the alignment. You can cut a chunk out of the washers, so that they are U shaped spacers instead. Saves you taking the bolt out ....
 
You must log in or register to reply here.

Similar threads

codfather79
Series 3 Bulkhead puzzle
Replies
4
Views
185
codfather79
codfather79
Paxmanmerv
The perennial brake problems
2
Replies
28
Views
2K
Paxmanmerv
Paxmanmerv
S
can i fit this on a series 3
Replies
9
Views
1K
boguing
boguing
G
Series 2A Windscreen Bulkhead pivot bolt
Replies
9
Views
2K
Guidoma
G
the_wolf
Straightening a 110 rear tub
Replies
2
Views
476
the_wolf
the_wolf
Back
Top