Can i do this?

Hi ho cowboys
Is it possible to use my rrclassis brak master cylinder and servo and fit it to my lr90? id like to use both axels off rangie, however the lr90 has a single line brake circuit but the rangie has a dual line.
I was thinking i could just take the rrc master cylinder and bolt it to the lr90s servo and then use the better rrc brakes. But i noticed the rrc has a bigger servo and wondered if i could the rrc's servo and benifit from better braking. Also, save myself money as my 90's front brakes look like they just been washed up in the last tide!
So to sumerise: Can i use the rrc brake master cylinder in place of my lr90 master cylinder?
Or will i have to take the servo off as well?
Is it possible?

If it will fit it should work.

shouldnt have a problem i dont think,

Woo Hoo!
Gonna give it a try i recon, but as the rrc has better brakes, cause she a heavy old lump of a motor, does that mean the lr90 will just skid all over the place when t touch the brakes?
Any one a brake Guru?

nah, doubt it will be as skitty as yer think, depends on yer tyres a lot too, seen it done a few times , all worked well. slightly sharper if anything,
considering the 90 come from the factory with soft brakes, its a hell of an improvement, mine are in top condition, they still dont "stop" as they should, they just bring yer to a halt !