Can I boost my performance of the engine!!
- Thread starter jasperjj
- Start date
This site contains affiliate links for which LandyZone may be compensated if you make a purchase.
Nitrous. Or only drive downhill. You could probably throw a lot of money at a series engine and get a tiny power increase but I doubt it's worth it - it's got enough power to get your landy almost anywhere without breaking the drivechain. It could be your engine is old and tired or poorly set up and a recon or tune up might get you the results you're looking for.
the_wolf
Well-Known Member
- Posts
- 16,791
- Location
- Stonehouse, Scotland
Any idea what horsepower its putting out at the moment? Do remember that its not supposed to go fast, its a land rover
dominicbeesley
Well-Known Member
- Posts
- 1,701
- Location
- Hebden Bridge, West Yorkshire
A 9:1 head and a better carb (SU or DMTL) make a big difference. However if you want to find stuff like this out there is _loads_ of stuff about tuning on the internet and in lots of books. To get anywhere you will need to read a lot.
Also, as stated a SWB is not a sports car but it should be fairly nippy checkign compression, timing, state of the carburettor and tune, tappets, cam chain, cams, etc etc and get it running properly before trying to tweak it otherwise you'll be ****ing in the wind
Also, as stated a SWB is not a sports car but it should be fairly nippy checkign compression, timing, state of the carburettor and tune, tappets, cam chain, cams, etc etc and get it running properly before trying to tweak it otherwise you'll be ****ing in the wind
owl
Well-Known Member
- Posts
- 1,807
- Location
- Breaston Derbyshire
Its is indeed a landy but a little bit more power is a welcome bonus!
Land Raver
Well-Known Member
- Posts
- 2,015
- Location
- In the dog house
I think time and money is better spent on ensuring the running gear is all working well and efficiently. Fresh oils in gearbox, diffs etc. good wheel bearings, tracking set up correct, brakes not catching, uj's greased and tyres inflated correctly. You can't polish a turd, where the engine is concerned, if more power is needed i would go down the engine change route. Personally, gently does it....i enjoy the retro leisurely pace 
landyladv8
New Member
- Posts
- 3
I remember reading about Janspeed turbocharging a 5MB 2 1/4, Think about the size of the 200Tdi turbo and using a drawthrough setup and made about 130-140 Bhp
Owh that's a lot better than the original bhpI remember reading about Janspeed turbocharging a 5MB 2 1/4, Think about the size of the 200Tdi turbo and using a drawthrough setup and made about 130-140 Bhp
owl
Well-Known Member
- Posts
- 1,807
- Location
- Breaston Derbyshire
noo I don't have a series, though if i did i would raise the CR and put a better carb on it just to improve the MPG.
Owh that's a lot better, than the original BhpI remember reading about Janspeed turbocharging a 5MB 2 1/4, Think about the size of the 200Tdi turbo and using a drawthrough setup and made about 130-140 Bhp
martin1512
Well-Known Member
- Posts
- 3,941
- Location
- Half way up a cliff in Dorset
Take out the old engine and fit a V8. Lots more power & torque, but about the same MPG.
Edit, just don't ask Dr Evil to do the conversion for you
Edit, just don't ask Dr Evil to do the conversion for you
Take out the old engine and fit a V8. Lots more power & torque, but about the same MPG.
Edit, just don't ask Dr Evil to do the conversion for you
....and uprate the gearbox, rest of the drivechain and the brakes. With power comes responsibility......
How deep are your pockets for fuel? I had a 2.25 petrol that was set up well and did around 13 mpg around town on very short runs. 18 to 20 max on long runs. A V8 I ran was no worse, I now run a 2.25 diesel Slow yes but 26/27 mpg. Remember the transmission wont take a big power increase all series boxes are now long in the tooth and have usually had a rebuild or two. A good choice is a 200tdi Disco engine and leave the turbo off this will give a nice safe 70/75 hp
dominicbeesley
Well-Known Member
- Posts
- 1,701
- Location
- Hebden Bridge, West Yorkshire
I got the Stage 2.1 head and hi torque cam from ACR. I went with a DMTL Weber though not their SU kit. I get 20mpg on the lanes round here and about the same at 80 on the motorway. I'd probably get better mileage locally but I spend probably 70% of the time on the choke. I've had 25mpg on one 45mph long run. I measure full tank to full tank for accuracy.
I've tuned the Carb at stoich for idle and cruise and very slightly rich at WOT. I could probably get another couple of mpg by dropping one idle jet size and one main jet 1/2 size without affecting driveability.
I've also put on Range Rover diffs and an overdrive. It now drives lovely, uses less fuel and will fly up hills (even with the higher diff ratio).
I've spent a fair amount on the engine and enjoyed every minute of it. If you're not a tinkerer or got limitless time but deep pockets I'd be very tempted by their 2.8 engine...again though I'd still put DMTL Weber on it....
Just added a spare wheel carrier on the back instead of carrying it on the bonnet it now goes round corners at speed instead of acting like a bucking broncho!
I've tuned the Carb at stoich for idle and cruise and very slightly rich at WOT. I could probably get another couple of mpg by dropping one idle jet size and one main jet 1/2 size without affecting driveability.
I've also put on Range Rover diffs and an overdrive. It now drives lovely, uses less fuel and will fly up hills (even with the higher diff ratio).
I've spent a fair amount on the engine and enjoyed every minute of it. If you're not a tinkerer or got limitless time but deep pockets I'd be very tempted by their 2.8 engine...again though I'd still put DMTL Weber on it....
Just added a spare wheel carrier on the back instead of carrying it on the bonnet it now goes round corners at speed instead of acting like a bucking broncho!
Take out the old engine and fit a V8. Lots more power & torque, but about the same MPG.
Edit, just don't ask Dr Evil to do the conversion for you
Yeahh that's are one of my ideas but that's not for now. That's for in a few years.
Not deep, but I think a v8 is the best solution to my "problem".
