Can anybody help to decode my Engine Number?
- Thread starter MS_Raptor
- Start date
This site contains affiliate links for which LandyZone may be compensated if you make a purchase.
Shimsteriom
Master Procrastinator
- Posts
- 41,905
- Location
- Over Here
Welcome 
yes sorry, I was a little bit in panic because of the engine number, hello everybody!Welcome
- Posts
- 33,890
- Location
- North Shropshire
Hi! Never met someone panicking over an engine number before
If it looks like a v8 and sounds like a v8, it must be a v8.
If it looks like a v8 and sounds like a v8, it must be a v8.
- Posts
- 33,890
- Location
- North Shropshire
Ah, i see. Fun stealers!!
- Posts
- 33,890
- Location
- North Shropshire
Where are you getting the engine number from?...thats not a V8 engine number...its stamped to the left of the dipstick on the block... that looks like a casting number...
Last edited:
If the engine has been replaced at any time & a Rover block used the number may not be by the dipstick but on top of the rear of the block on the left-hand (as viewed from the driver's seat looking forward) bank of the V. May need a mirror to see it.
Henry_b
Think outside, no box required.
- Posts
- 15,509
- Location
- somewhere else
That is the cast number for a 4.0 thor
Depending on the cast, upto 1998-99, they used the HRC2411 casting. After this particular date rover V8 blocks used the LCF000250 casting all D2's introduced around 1998 in euro and about half of the P38 production used the same casting. All D1's used the HRC2411 casting.
Depending on the cast, upto 1998-99, they used the HRC2411 casting. After this particular date rover V8 blocks used the LCF000250 casting all D2's introduced around 1998 in euro and about half of the P38 production used the same casting. All D1's used the HRC2411 casting.
- Posts
- 16,481
- Location
- Benfleet, Essex
FIRST-LINE is Compression Ratio (CR"X.YZ":1)
Second Line "Engine Serial Number in Full."
Last edited:
That is the cast number for a 4.0 thor
Depending on the cast, upto 1998-99, they used the HRC2411 casting. After this particular date rover V8 blocks used the LCF000250 casting all D2's introduced around 1998 in euro and about half of the P38 production used the same casting. All D1's used the HRC2411 casting.
As I said before cast number... engine number on a disco 3.5 V8 should start with example... 23Dxxxxx amongst others...
